Home > general bluez > Cisco ASA failover fail if IPv6 enabled

Cisco ASA failover fail if IPv6 enabled

October 2nd, 2009 sIMON Leave a comment Go to comments

I can’t believe it…

Failover on Cisco ASA silently stops working after you enable ipv6 configuration.

We’re used of stupid Cisco bugs, but this wins it all !

S.

Categories: general bluez Tags: , ,
  1. miha
    October 2nd, 2009 at 19:15 | #1
    Reply | Quote

    Salabajzerji!

  2. sIMON
    October 2nd, 2009 at 21:36 | #2
    Reply | Quote

    Miha !

    A ves da to je bil tist problem… ko je reku duplicate :-) isti IP je dal na obe asi in je pol itak mel duplicate !!!

    stupid stupid stupid !

  1. No trackbacks yet.